Technology manufacturing floor

Comfort in any room, office, home, creates a first floor. Poorly Lead styling, creaking or even, making a note of irritation. During the repair, yet it should be paid attention to. Production of floors is divided into three parts: Remove old paint, flooring then new coating and alignment.

The simplest process of repair, may be called disassembly. The old coating is removed very carefully so as not to damage the substrate. The next step of alignment can be made using the construction of precast floor also by means of tie sand and cement (such a method is applied when the surface requires the alignment of more than 3 cm), filling the pores and priming. Such work is usually carried out on their own builders and making them is not recommended.

Production of floors using self-leveling leveling compounds. The advantage of such mixtures is the fact that filling all the cracks, they form a thin tie, so the height of the room will not be affected. However, such a surface, long withers and can vspuchilis so after pouring on it traversed a spiked roller or a passage in a special shoe to remove the remaining air in the mixture, and nodules.

Dry styazhki- this innovation. They are quite efficient in comparison with for example cement-sand. They are used both in the construction of new buildings and in the repair of apartments. To align the sand is used with a special composition. This method allows us to produce the perfect outdoor surface to eliminate any, even the substantial flaws.

In order to produce high-quality surface, you need to properly perform preparatory work. You will need a laser or water level. Across the room it needs to "recapture" the zero level at a comfortable height for you. Randomly placed a mark, then use the level it is transferred to the other walls. Markers must be connected to each other, this line will be zero. So is determined rank.

The next step will be to identify differences and floor height. It is necessary for the proper calculation of the flow, and to correct billing ties. It is necessary to measure the distance from the zero level to the bottom in different places. On the wall distance recorded at each point. The highest will mean the lowest part of the lowest-highest part. They say the difference is how much height difference. Next, you need to follow the manufacturer's recommendations, the mixture used. Avoid frequent repairs can only be done properly work.